PenangAPRS Track

My position About ☰

reset

SP3KON-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KON-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1773793050	236 Count	596 Count	80 Count
1773792149	233 Count	585 Count	78 Count
1773791248	230 Count	575 Count	76 Count
1773790347	226 Count	563 Count	73 Count
1773789446	219 Count	555 Count	72 Count
1773788545	212 Count	543 Count	70 Count
1773787645	209 Count	526 Count	68 Count
1773786744	206 Count	515 Count	66 Count
1773785843	202 Count	499 Count	63 Count
1773784942	199 Count	484 Count	61 Count
1773784041	194 Count	464 Count	57 Count
1773783140	190 Count	450 Count	54 Count
1773782239	177 Count	426 Count	50 Count
1773781338	172 Count	409 Count	47 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)