PenangAPRS Track

My position About ☰

reset

F5ZYM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZYM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786405725	241 Count	370 Count	204 Count
1786404820	233 Count	358 Count	197 Count
1786403916	225 Count	346 Count	190 Count
1786403012	217 Count	332 Count	183 Count
1786402108	210 Count	318 Count	177 Count
1786401204	203 Count	307 Count	171 Count
1786400300	197 Count	298 Count	166 Count
1786399393	190 Count	283 Count	160 Count
1786398590	184 Count	274 Count	155 Count
1786397686	179 Count	265 Count	151 Count
1786396781	173 Count	258 Count	146 Count
1786395878	168 Count	253 Count	142 Count
1786394973	164 Count	246 Count	139 Count
1786394069	158 Count	239 Count	134 Count
1786393165	152 Count	232 Count	129 Count
1786392261	147 Count	226 Count	125 Count
1786391357	141 Count	219 Count	120 Count
1786390453	136 Count	213 Count	116 Count
1786389549	131 Count	208 Count	112 Count
1786388645	126 Count	203 Count	108 Count
1786387741	121 Count	198 Count	104 Count
1786386837	116 Count	193 Count	100 Count
1786385932	111 Count	188 Count	96 Count
1786385028	107 Count	184 Count	93 Count
1786384124	103 Count	178 Count	90 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)