PenangAPRS Track

My position About ☰

reset

SP2WM-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WM-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794338515	560 Count	853 Count	294 Count
1794337614	559 Count	853 Count	294 Count
1794336714	558 Count	853 Count	294 Count
1794335813	557 Count	853 Count	294 Count
1794334912	556 Count	853 Count	294 Count
1794334011	553 Count	851 Count	292 Count
1794333110	551 Count	850 Count	291 Count
1794332210	550 Count	850 Count	291 Count
1794331309	549 Count	850 Count	291 Count
1794330408	548 Count	850 Count	291 Count
1794329507	547 Count	850 Count	291 Count
1794328607	546 Count	850 Count	291 Count
1794327706	545 Count	850 Count	291 Count
1794326805	544 Count	850 Count	291 Count
1794325904	542 Count	849 Count	290 Count
1794325004	541 Count	849 Count	290 Count
1794324103	540 Count	849 Count	290 Count
1794323202	539 Count	849 Count	290 Count
1794322302	537 Count	847 Count	289 Count
1794321400	535 Count	844 Count	288 Count
1794320500	532 Count	840 Count	286 Count
1794319599	526 Count	827 Count	281 Count
1794318698	523 Count	804 Count	279 Count
1794317815	516 Count	798 Count	277 Count
1794316914	514 Count	781 Count	276 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)