PenangAPRS Track

My position About ☰

reset

SP8SD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786416034	227 Count	418 Count	207 Count
1786415734	216 Count	404 Count	197 Count
1786415433	199 Count	371 Count	181 Count
1786415133	182 Count	336 Count	165 Count
1786414832	175 Count	325 Count	159 Count
1786414531	169 Count	315 Count	154 Count
1786414231	160 Count	297 Count	146 Count
1786413930	153 Count	287 Count	140 Count
1786413630	146 Count	268 Count	134 Count
1786413329	136 Count	253 Count	125 Count
1786413029	130 Count	242 Count	120 Count
1786412728	118 Count	219 Count	109 Count
1786412127	93 Count	165 Count	86 Count
1786411826	79 Count	141 Count	73 Count
1786411526	65 Count	117 Count	60 Count
1786411228	49 Count	85 Count	45 Count
1786410924	40 Count	71 Count	37 Count
1786410624	35 Count	62 Count	33 Count
1786410323	27 Count	49 Count	26 Count
1786410023	20 Count	37 Count	20 Count
1786409722	645 Count	1049 Count	588 Count
1786409420	613 Count	1000 Count	557 Count
1786409407	540 Count	897 Count	486 Count
1786409120	577 Count	954 Count	522 Count
1786408817	540 Count	897 Count	486 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 1, 0

V_Ext: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)