PenangAPRS Track

My position About ☰

reset

SZ1SV-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SZ1SV-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786406235	790 Count	962 Count	568 Count
1786405332	786 Count	952 Count	565 Count
1786404429	780 Count	946 Count	560 Count
1786403526	777 Count	942 Count	558 Count
1786402623	772 Count	937 Count	554 Count
1786401720	770 Count	935 Count	553 Count
1786400817	767 Count	932 Count	551 Count
1786399914	762 Count	925 Count	547 Count
1786399011	759 Count	921 Count	545 Count
1786398108	755 Count	916 Count	542 Count
1786397205	751 Count	909 Count	539 Count
1786396302	748 Count	905 Count	537 Count
1786395398	744 Count	896 Count	534 Count
1786394496	742 Count	894 Count	533 Count
1786393592	740 Count	890 Count	532 Count
1786392689	738 Count	885 Count	531 Count
1786391787	736 Count	884 Count	530 Count
1786390883	735 Count	884 Count	530 Count
1786389974	731 Count	880 Count	527 Count
1786389070	729 Count	879 Count	526 Count
1786388168	728 Count	879 Count	526 Count
1786387264	727 Count	879 Count	526 Count
1786386361	725 Count	874 Count	525 Count
1786385458	723 Count	871 Count	524 Count
1786384555	720 Count	867 Count	522 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)