PenangAPRS Track

My position About ☰

reset

SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790324332	93 Count	289 Count	83 Count
1790322529	80 Count	245 Count	71 Count
1790320726	63 Count	195 Count	55 Count
1790318923	48 Count	147 Count	41 Count
1790317120	32 Count	98 Count	26 Count
1790313514	4 Count	0 Count	0 Count
1790311744	268 Count	971 Count	245 Count
1790309941	255 Count	923 Count	233 Count
1790308138	239 Count	861 Count	218 Count
1790306335	221 Count	809 Count	201 Count
1790304532	208 Count	758 Count	189 Count
1790302729	192 Count	702 Count	174 Count
1790300926	178 Count	653 Count	161 Count
1790299123	164 Count	604 Count	148 Count
1790297320	151 Count	558 Count	136 Count
1790295517	138 Count	509 Count	124 Count
1790293714	127 Count	461 Count	114 Count
1790291911	114 Count	409 Count	102 Count
1790290142	97 Count	364 Count	90 Count
1790288339	86 Count	322 Count	80 Count
1790286536	75 Count	277 Count	70 Count
1790284733	62 Count	228 Count	58 Count
1790282930	49 Count	184 Count	46 Count
1790281127	38 Count	138 Count	36 Count
1790279323	25 Count	87 Count	24 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)