PenangAPRS Track

My position About ☰

reset

SR8ULZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8ULZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790299940	193 Count	586 Count	83 Count
1790298140	191 Count	585 Count	82 Count
1790296339	189 Count	584 Count	81 Count
1790294538	187 Count	583 Count	80 Count
1790292738	185 Count	582 Count	79 Count
1790290937	183 Count	581 Count	78 Count
1790289143	177 Count	580 Count	77 Count
1790287343	175 Count	579 Count	76 Count
1790285542	173 Count	578 Count	75 Count
1790283741	171 Count	577 Count	74 Count
1790281940	169 Count	576 Count	73 Count
1790280140	167 Count	575 Count	72 Count
1790278339	165 Count	574 Count	71 Count
1790276539	163 Count	573 Count	70 Count
1790274738	161 Count	572 Count	69 Count
1790272937	159 Count	571 Count	68 Count
1790271137	156 Count	569 Count	66 Count
1790269336	154 Count	568 Count	65 Count
1790267542	148 Count	567 Count	64 Count
1790265742	146 Count	566 Count	63 Count
1790263941	144 Count	565 Count	62 Count
1790262140	142 Count	564 Count	61 Count
1790260340	140 Count	563 Count	60 Count
1790258539	138 Count	562 Count	59 Count
1790256738	136 Count	561 Count	58 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)