PenangAPRS Track

My position About ☰

reset

SQ3KT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3KT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1764976065	22 Count	59 Count	20 Count
1764975164	16 Count	43 Count	15 Count
1764974264	7 Count	19 Count	7 Count
1764973363	363 Count	1004 Count	309 Count
1764972462	359 Count	992 Count	306 Count
1764971561	354 Count	982 Count	302 Count
1764970661	345 Count	959 Count	294 Count
1764969760	334 Count	937 Count	284 Count
1764968859	331 Count	927 Count	282 Count
1764967967	326 Count	913 Count	278 Count
1764967066	315 Count	887 Count	268 Count
1764966165	305 Count	869 Count	259 Count
1764965264	302 Count	859 Count	257 Count
1764964363	291 Count	836 Count	247 Count
1764963463	282 Count	809 Count	239 Count
1764962562	273 Count	779 Count	231 Count
1764961661	270 Count	771 Count	229 Count
1764960760	264 Count	754 Count	224 Count
1764959860	254 Count	725 Count	215 Count
1764958959	250 Count	710 Count	212 Count
1764958058	247 Count	694 Count	210 Count
1764957157	243 Count	672 Count	207 Count
1764956257	233 Count	647 Count	198 Count
1764955356	223 Count	624 Count	189 Count
1764954455	220 Count	599 Count	187 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)