PenangAPRS Track

My position About ☰

reset

SP4SR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4SR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764957445	359 Count	86 Count
1764955645	358 Count	85 Count
1764953844	357 Count	84 Count
1764952042	356 Count	84 Count
1764950242	355 Count	84 Count
1764948441	354 Count	84 Count
1764946641	353 Count	84 Count
1764944841	352 Count	84 Count
1764943040	351 Count	84 Count
1764941239	350 Count	81 Count
1764935844	343 Count	80 Count
1764934044	342 Count	80 Count
1764932244	341 Count	80 Count
1764930442	340 Count	80 Count
1764928642	339 Count	80 Count
1764926841	338 Count	80 Count
1764925041	337 Count	80 Count
1764923241	336 Count	80 Count
1764921439	335 Count	80 Count
1764919639	334 Count	80 Count
1764917837	333 Count	80 Count
1764914243	327 Count	80 Count
1764910642	325 Count	80 Count
1764908841	324 Count	80 Count
1764907041	323 Count	80 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)