PenangAPRS Track

My position About ☰

reset

SP9KKK-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1786397830	21 Count	808 Count
1786396629	19 Count	671 Count
1786395428	16 Count	610 Count
1786394227	11 Count	445 Count
1786393025	8 Count	196 Count
1786391825	5 Count	135 Count
1786390624	0 Count	0 Count
1786389433	26 Count	895 Count
1786388232	23 Count	843 Count
1786387031	18 Count	731 Count
1786385830	17 Count	601 Count
1786384630	14 Count	549 Count
1786383429	9 Count	421 Count
1786382228	7 Count	241 Count
1786381027	4 Count	147 Count
1786379826	33 Count	1056 Count
1786378625	31 Count	902 Count
1786377424	28 Count	842 Count
1786376223	23 Count	711 Count
1786375033	20 Count	582 Count
1786373832	17 Count	556 Count
1786372632	12 Count	440 Count
1786371431	10 Count	300 Count
1786370230	7 Count	250 Count
1786369029	2 Count	126 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)