PenangAPRS Track

My position About ☰

reset

SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780207399	116 Count	278 Count	20 Count
1780205598	115 Count	276 Count	20 Count
1780203797	114 Count	274 Count	20 Count
1780202005	113 Count	272 Count	20 Count
1780200204	112 Count	270 Count	20 Count
1780198403	111 Count	268 Count	20 Count
1780196602	110 Count	261 Count	20 Count
1780194802	109 Count	259 Count	20 Count
1780193001	108 Count	257 Count	20 Count
1780191200	107 Count	255 Count	20 Count
1780189400	106 Count	254 Count	20 Count
1780187599	105 Count	252 Count	20 Count
1780185798	104 Count	250 Count	20 Count
1780183997	103 Count	248 Count	20 Count
1780182196	102 Count	247 Count	20 Count
1780180404	101 Count	245 Count	20 Count
1780178603	100 Count	243 Count	20 Count
1780176802	99 Count	241 Count	20 Count
1780175002	98 Count	234 Count	20 Count
1780173201	97 Count	232 Count	20 Count
1780171400	96 Count	231 Count	20 Count
1780169599	95 Count	229 Count	20 Count
1780167798	94 Count	227 Count	20 Count
1780165997	93 Count	225 Count	20 Count
1780164196	92 Count	223 Count	20 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)