PenangAPRS Track

My position About ☰

reset

SQ2MO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1794331067	107 Count	502 Count	7 Count
1794329866	106 Count	480 Count	7 Count
1794328666	105 Count	455 Count	7 Count
1794327465	104 Count	435 Count	7 Count
1794325075	98 Count	422 Count	7 Count
1794323874	97 Count	418 Count	7 Count
1794322673	96 Count	414 Count	7 Count
1794321472	95 Count	409 Count	7 Count
1794320271	94 Count	405 Count	7 Count
1794319071	92 Count	399 Count	6 Count
1794317870	91 Count	393 Count	6 Count
1794316669	90 Count	389 Count	6 Count
1794315469	89 Count	385 Count	6 Count
1794314268	88 Count	383 Count	6 Count
1794313068	87 Count	350 Count	6 Count
1794311867	86 Count	345 Count	6 Count
1794310666	85 Count	343 Count	6 Count
1794309466	84 Count	339 Count	6 Count
1794308265	83 Count	335 Count	6 Count
1794307064	82 Count	333 Count	6 Count
1794305864	81 Count	326 Count	6 Count
1794303472	75 Count	302 Count	6 Count
1794302272	74 Count	280 Count	6 Count
1794301071	71 Count	269 Count	4 Count
1794299871	70 Count	269 Count	4 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)