PenangAPRS Track

My position About ☰

reset

EB2BRA-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB2BRA-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790316956	9 Count	319 Count
1790315193	8 Count	291 Count
1790313390	7 Count	264 Count
1790311587	6 Count	239 Count
1790309783	5 Count	206 Count
1790307980	4 Count	172 Count
1790306176	3 Count	139 Count
1790304373	2 Count	102 Count
1790302569	1 Count	61 Count
1790300766	0 Count	29 Count
1790298962	35 Count	1009 Count
1790297159	34 Count	989 Count
1790295356	33 Count	963 Count
1790293592	32 Count	944 Count
1790291789	31 Count	918 Count
1790289986	30 Count	893 Count
1790288182	29 Count	864 Count
1790286379	28 Count	847 Count
1790284575	27 Count	822 Count
1790282772	26 Count	759 Count
1790280969	25 Count	680 Count
1790279165	24 Count	652 Count
1790277362	23 Count	615 Count
1790275558	22 Count	586 Count
1790273755	21 Count	547 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)