PenangAPRS Track

My position About ☰

reset

SQ7RJZ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7RJZ-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780182562	310 Count	57 Count	22 Count
1780180761	309 Count	57 Count	22 Count
1780178960	308 Count	57 Count	22 Count
1780177159	307 Count	57 Count	22 Count
1780175359	306 Count	57 Count	22 Count
1780173558	305 Count	57 Count	22 Count
1780171757	304 Count	57 Count	22 Count
1780169964	303 Count	57 Count	22 Count
1780168163	302 Count	57 Count	22 Count
1780166362	301 Count	57 Count	22 Count
1780164562	300 Count	57 Count	22 Count
1780162761	299 Count	57 Count	22 Count
1780160960	298 Count	57 Count	22 Count
1780159159	296 Count	54 Count	22 Count
1780157359	292 Count	51 Count	22 Count
1780155558	288 Count	49 Count	22 Count
1780153757	286 Count	45 Count	22 Count
1780151956	283 Count	42 Count	22 Count
1780150156	279 Count	41 Count	22 Count
1780148364	276 Count	38 Count	22 Count
1780146563	273 Count	36 Count	22 Count
1780144762	270 Count	34 Count	22 Count
1780142961	267 Count	31 Count	22 Count
1780141161	264 Count	28 Count	22 Count
1780139361	261 Count	26 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)