PenangAPRS Track

My position About ☰

reset

SP3PZL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3PZL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794343881	580 Count	99 Count	71 Count
1794342080	579 Count	99 Count	71 Count
1794338091	576 Count	99 Count	71 Count
1794336290	575 Count	99 Count	71 Count
1794334489	574 Count	99 Count	71 Count
1794332689	573 Count	99 Count	71 Count
1794330888	572 Count	99 Count	71 Count
1794329088	571 Count	99 Count	71 Count
1794327137	570 Count	99 Count	71 Count
1794325336	569 Count	99 Count	71 Count
1794323535	568 Count	99 Count	71 Count
1794321735	567 Count	99 Count	71 Count
1794319934	566 Count	99 Count	71 Count
1794318133	565 Count	99 Count	71 Count
1794314532	563 Count	99 Count	71 Count
1794312731	562 Count	99 Count	71 Count
1794309130	560 Count	99 Count	71 Count
1794307330	559 Count	99 Count	71 Count
1794303738	557 Count	99 Count	71 Count
1794301937	556 Count	99 Count	71 Count
1794300136	555 Count	99 Count	71 Count
1794298336	554 Count	99 Count	71 Count
1794296535	553 Count	99 Count	71 Count
1794294734	552 Count	99 Count	71 Count
1794291133	550 Count	99 Count	71 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)