PenangAPRS Track

My position About ☰

reset

F6ZBY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6ZBY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780180245	66 Count	93 Count	55 Count
1780178442	61 Count	87 Count	51 Count
1780176639	54 Count	79 Count	45 Count
1780174835	48 Count	70 Count	40 Count
1780173032	43 Count	62 Count	36 Count
1780171229	38 Count	54 Count	32 Count
1780169426	32 Count	46 Count	27 Count
1780167623	26 Count	38 Count	22 Count
1780165820	20 Count	29 Count	17 Count
1780164055	15 Count	22 Count	13 Count
1780162252	9 Count	14 Count	8 Count
1780160449	4 Count	7 Count	4 Count
1780158646	588 Count	1002 Count	543 Count
1780156843	583 Count	996 Count	539 Count
1780155040	578 Count	989 Count	535 Count
1780153237	573 Count	983 Count	531 Count
1780151434	568 Count	977 Count	527 Count
1780149631	563 Count	970 Count	523 Count
1780147828	558 Count	964 Count	519 Count
1780146024	553 Count	958 Count	515 Count
1780144221	548 Count	953 Count	511 Count
1780142455	543 Count	947 Count	507 Count
1780140652	538 Count	942 Count	503 Count
1780138849	533 Count	935 Count	499 Count
1780137046	528 Count	929 Count	495 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)