PenangAPRS Track

My position About ☰

reset

SQ8PDY-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8PDY-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773733309	17 Count	154 Count	16 Count
1773731508	10 Count	84 Count	10 Count
1773729708	234 Count	1047 Count	205 Count
1773727907	225 Count	979 Count	197 Count
1773726106	214 Count	938 Count	187 Count
1773724306	205 Count	903 Count	179 Count
1773722505	202 Count	894 Count	177 Count
1773720705	193 Count	857 Count	169 Count
1773718904	178 Count	811 Count	155 Count
1773713502	149 Count	718 Count	129 Count
1773711707	131 Count	681 Count	116 Count
1773709907	122 Count	644 Count	108 Count
1773708106	110 Count	590 Count	97 Count
1773706306	101 Count	550 Count	89 Count
1773704505	89 Count	517 Count	78 Count
1773702704	80 Count	479 Count	70 Count
1773700904	69 Count	443 Count	60 Count
1773699103	60 Count	395 Count	52 Count
1773697303	45 Count	333 Count	38 Count
1773695502	36 Count	284 Count	30 Count
1773693701	24 Count	165 Count	19 Count
1773691901	4 Count	0 Count	0 Count
1773690106	210 Count	947 Count	190 Count
1773688306	194 Count	875 Count	175 Count
1773686505	182 Count	823 Count	164 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)