PenangAPRS Track

My position About ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790300786	60 Count	475 Count	25 Count
1790300186	59 Count	462 Count	25 Count
1790299585	57 Count	450 Count	24 Count
1790298984	55 Count	435 Count	23 Count
1790298383	54 Count	422 Count	23 Count
1790297782	52 Count	410 Count	22 Count
1790297182	50 Count	396 Count	21 Count
1790296581	49 Count	385 Count	21 Count
1790295981	47 Count	373 Count	20 Count
1790295380	45 Count	360 Count	19 Count
1790294779	44 Count	347 Count	19 Count
1790294179	42 Count	335 Count	18 Count
1790293578	40 Count	321 Count	17 Count
1790292977	39 Count	307 Count	17 Count
1790292377	37 Count	293 Count	16 Count
1790291776	35 Count	278 Count	15 Count
1790291176	34 Count	264 Count	15 Count
1790290575	32 Count	250 Count	14 Count
1790289974	30 Count	236 Count	13 Count
1790289374	29 Count	213 Count	13 Count
1790288773	27 Count	201 Count	12 Count
1790288172	25 Count	187 Count	11 Count
1790287572	24 Count	175 Count	11 Count
1790286971	22 Count	163 Count	10 Count
1790286371	20 Count	149 Count	9 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)