PenangAPRS Track

My position About ☰

reset

EB5BZM-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1794354094	67 Count	966 Count
1794352052	66 Count	964 Count
1794350012	65 Count	962 Count
1794348822	64 Count	960 Count
1794346781	63 Count	958 Count
1794344739	62 Count	955 Count
1794342698	61 Count	953 Count
1794340657	60 Count	950 Count
1794338616	59 Count	947 Count
1794336575	58 Count	944 Count
1794334533	57 Count	940 Count
1794332493	56 Count	925 Count
1794330452	55 Count	890 Count
1794328411	54 Count	877 Count
1794327217	53 Count	858 Count
1794325176	52 Count	853 Count
1794323135	51 Count	843 Count
1794321094	50 Count	806 Count
1794319054	49 Count	792 Count
1794317013	48 Count	773 Count
1794314972	47 Count	767 Count
1794312931	46 Count	736 Count
1794310891	45 Count	724 Count
1794308850	44 Count	711 Count
1794306809	43 Count	622 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)