PenangAPRS Track

My position About ☰

reset

LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794349400	449 Count	521 Count	378 Count
1794347596	443 Count	514 Count	373 Count
1794345793	437 Count	496 Count	368 Count
1794343990	431 Count	490 Count	363 Count
1794342187	425 Count	483 Count	358 Count
1794340424	419 Count	476 Count	353 Count
1794338620	413 Count	469 Count	348 Count
1794336817	405 Count	459 Count	341 Count
1794335014	399 Count	453 Count	336 Count
1794333210	393 Count	446 Count	331 Count
1794331407	386 Count	438 Count	325 Count
1794329604	380 Count	431 Count	320 Count
1794327800	374 Count	424 Count	315 Count
1794325997	368 Count	417 Count	310 Count
1794324193	362 Count	410 Count	305 Count
1794322390	356 Count	403 Count	300 Count
1794320587	350 Count	396 Count	295 Count
1794318824	344 Count	389 Count	290 Count
1794317020	338 Count	382 Count	285 Count
1794315217	330 Count	373 Count	278 Count
1794313414	325 Count	367 Count	274 Count
1794311611	319 Count	361 Count	269 Count
1794309807	312 Count	352 Count	263 Count
1794308004	306 Count	345 Count	258 Count
1794306201	300 Count	338 Count	253 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)