PenangAPRS Track

My position About ☰

reset

SQ9PD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1764958066	11 Count	105 Count	10 Count
1764957165	5 Count	56 Count	5 Count
1764956265	117 Count	1012 Count	94 Count
1764955364	112 Count	962 Count	90 Count
1764954463	106 Count	909 Count	85 Count
1764953562	101 Count	865 Count	81 Count
1764952662	95 Count	817 Count	76 Count
1764951761	90 Count	751 Count	72 Count
1764950877	80 Count	711 Count	67 Count
1764949976	76 Count	671 Count	64 Count
1764949076	70 Count	612 Count	59 Count
1764948175	65 Count	577 Count	55 Count
1764947274	59 Count	522 Count	50 Count
1764946374	53 Count	409 Count	45 Count
1764945472	46 Count	306 Count	39 Count
1764944571	42 Count	272 Count	36 Count
1764943671	35 Count	239 Count	30 Count
1764942770	29 Count	196 Count	25 Count
1764941869	23 Count	154 Count	20 Count
1764940969	15 Count	113 Count	13 Count
1764940068	9 Count	72 Count	8 Count
1764939167	4 Count	43 Count	4 Count
1764938266	94 Count	1030 Count	72 Count
1764937366	91 Count	993 Count	70 Count
1764936465	84 Count	950 Count	64 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)