PenangAPRS Track

My position About ☰

reset

SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1786441579	43 Count	386 Count
1786439778	41 Count	376 Count
1786437978	40 Count	368 Count
1786436177	39 Count	358 Count
1786434376	38 Count	340 Count
1786432576	37 Count	322 Count
1786430782	36 Count	315 Count
1786428981	35 Count	309 Count
1786427181	34 Count	301 Count
1786425380	33 Count	293 Count
1786423580	32 Count	285 Count
1786421779	31 Count	277 Count
1786419979	30 Count	269 Count
1786418178	29 Count	261 Count
1786416377	28 Count	249 Count
1786414576	27 Count	241 Count
1786412776	26 Count	233 Count
1786410975	25 Count	225 Count
1786409182	24 Count	217 Count
1786407381	23 Count	209 Count
1786405580	22 Count	201 Count
1786403780	21 Count	193 Count
1786401979	20 Count	185 Count
1786400178	19 Count	177 Count
1786398378	18 Count	169 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)