PenangAPRS Track

My position About ☰

reset

IT9IRS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1780259241	136 Count	973 Count
1780258338	135 Count	967 Count
1780257434	134 Count	952 Count
1780255627	132 Count	927 Count
1780254724	131 Count	917 Count
1780253820	130 Count	908 Count
1780252917	129 Count	898 Count
1780252013	128 Count	888 Count
1780251110	127 Count	882 Count
1780250206	126 Count	868 Count
1780249303	125 Count	857 Count
1780248399	124 Count	846 Count
1780247496	123 Count	839 Count
1780247438	118 Count	839 Count
1780247126	113 Count	834 Count
1780246992	105 Count	833 Count
1780246280	100 Count	828 Count
1780245377	99 Count	815 Count
1780244473	98 Count	807 Count
1780243570	97 Count	796 Count
1780242666	96 Count	787 Count
1780241763	95 Count	776 Count
1780240859	94 Count	768 Count
1780239052	92 Count	750 Count
1780238235	87 Count	740 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)