PenangAPRS Track

My position About ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794357365	13 Count	167 Count	12 Count
1794355565	5 Count	59 Count	5 Count
1794353764	234 Count	1027 Count	220 Count
1794351963	228 Count	990 Count	215 Count
1794350162	221 Count	955 Count	209 Count
1794348361	208 Count	922 Count	197 Count
1794346560	201 Count	882 Count	191 Count
1794344760	193 Count	825 Count	184 Count
1794342959	187 Count	795 Count	179 Count
1794341158	177 Count	766 Count	170 Count
1794339358	169 Count	721 Count	163 Count
1794337557	163 Count	675 Count	158 Count
1794335756	151 Count	598 Count	147 Count
1794333956	112 Count	472 Count	109 Count
1794332155	79 Count	289 Count	77 Count
1794330354	45 Count	144 Count	44 Count
1794328554	22 Count	79 Count	22 Count
1794326753	182 Count	1117 Count	171 Count
1794324952	163 Count	983 Count	153 Count
1794323152	141 Count	848 Count	132 Count
1794321351	121 Count	737 Count	113 Count
1794319553	90 Count	646 Count	83 Count
1794317750	71 Count	441 Count	65 Count
1794315964	39 Count	245 Count	38 Count
1794314171	21 Count	122 Count	21 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)