PenangAPRS Track

My position About ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1794356703	13 Count	150 Count
1794354900	12 Count	133 Count
1794353097	11 Count	118 Count
1794351293	8 Count	106 Count
1794349490	7 Count	97 Count
1794347686	6 Count	81 Count
1794345883	5 Count	67 Count
1794344120	2 Count	54 Count
1794342317	1 Count	37 Count
1794340513	0 Count	15 Count
1794338710	93 Count	1007 Count
1794336907	90 Count	994 Count
1794335103	89 Count	989 Count
1794333300	88 Count	974 Count
1794331496	87 Count	970 Count
1794329693	84 Count	955 Count
1794327890	83 Count	941 Count
1794326086	82 Count	924 Count
1794324283	81 Count	909 Count
1794322522	78 Count	882 Count
1794320718	77 Count	862 Count
1794318915	76 Count	844 Count
1794317112	75 Count	809 Count
1794315308	72 Count	790 Count
1794313505	71 Count	773 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)