PenangAPRS Track

My position About ☰

reset

IZ5IOM-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ5IOM-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1794313863	2 Count	176 Count
1794312059	1 Count	128 Count
1794310256	0 Count	63 Count
1794308452	17 Count	1005 Count
1794306649	16 Count	949 Count
1794304845	15 Count	898 Count
1794303042	14 Count	844 Count
1794301238	13 Count	785 Count
1794299435	12 Count	730 Count
1794297778	11 Count	682 Count
1794295974	10 Count	605 Count
1794294171	9 Count	551 Count
1794292367	8 Count	479 Count
1794290564	7 Count	419 Count
1794288761	6 Count	371 Count
1794286957	5 Count	315 Count
1794285153	4 Count	257 Count
1794283349	3 Count	212 Count
1794281546	2 Count	157 Count
1794279743	1 Count	110 Count
1794277939	0 Count	55 Count
1794276072	19 Count	1021 Count
1794274268	18 Count	968 Count
1794272465	17 Count	919 Count
1794270661	16 Count	875 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)