PenangAPRS Track

My position About ☰

reset

SQ4HSE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1769815335	436 Count	750 Count	305 Count
1769811735	433 Count	744 Count	303 Count
1769808133	430 Count	738 Count	301 Count
1769804532	427 Count	731 Count	299 Count
1769800931	424 Count	725 Count	297 Count
1769797330	421 Count	719 Count	295 Count
1769793729	418 Count	714 Count	293 Count
1769790127	415 Count	710 Count	291 Count
1769786527	412 Count	705 Count	289 Count
1769782925	409 Count	698 Count	287 Count
1769779325	406 Count	679 Count	285 Count
1769775724	403 Count	639 Count	283 Count
1769772122	400 Count	633 Count	281 Count
1769768522	394 Count	623 Count	276 Count
1769764921	391 Count	611 Count	274 Count
1769761320	388 Count	601 Count	272 Count
1769757719	385 Count	593 Count	270 Count
1769754118	382 Count	590 Count	268 Count
1769750518	379 Count	585 Count	266 Count
1769746917	376 Count	578 Count	264 Count
1769743316	373 Count	571 Count	262 Count
1769739715	370 Count	567 Count	260 Count
1769736114	367 Count	564 Count	258 Count
1769732513	364 Count	561 Count	256 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)