PenangAPRS Track

My position About ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769763742	185 Count	351 Count	97 Count
1769761941	183 Count	350 Count	96 Count
1769760146	181 Count	348 Count	95 Count
1769758345	180 Count	347 Count	95 Count
1769756544	179 Count	347 Count	95 Count
1769754744	177 Count	340 Count	94 Count
1769752943	175 Count	338 Count	93 Count
1769751142	174 Count	337 Count	93 Count
1769749341	173 Count	335 Count	93 Count
1769747541	171 Count	332 Count	92 Count
1769745740	168 Count	328 Count	90 Count
1769743939	165 Count	324 Count	88 Count
1769742139	164 Count	321 Count	88 Count
1769740338	163 Count	318 Count	88 Count
1769738545	160 Count	314 Count	86 Count
1769736745	157 Count	309 Count	84 Count
1769734944	154 Count	303 Count	82 Count
1769733143	152 Count	300 Count	81 Count
1769731342	150 Count	298 Count	80 Count
1769729542	148 Count	293 Count	79 Count
1769727741	146 Count	291 Count	78 Count
1769725940	145 Count	287 Count	78 Count
1769724140	144 Count	287 Count	78 Count
1769722339	142 Count	283 Count	77 Count
1769720538	140 Count	280 Count	76 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)