PenangAPRS Track

My position About ☰

reset

SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790306230	169 Count	373 Count	132 Count
1790305629	166 Count	366 Count	130 Count
1790305029	161 Count	355 Count	126 Count
1790304428	155 Count	342 Count	121 Count
1790303827	150 Count	329 Count	117 Count
1790303227	146 Count	321 Count	114 Count
1790302625	139 Count	305 Count	108 Count
1790302024	136 Count	297 Count	106 Count
1790301424	131 Count	288 Count	102 Count
1790300823	125 Count	273 Count	97 Count
1790300222	121 Count	264 Count	94 Count
1790299622	117 Count	255 Count	91 Count
1790299021	110 Count	241 Count	85 Count
1790298420	107 Count	227 Count	83 Count
1790297820	102 Count	218 Count	79 Count
1790297219	97 Count	206 Count	75 Count
1790296618	93 Count	196 Count	72 Count
1790296017	89 Count	187 Count	69 Count
1790295417	84 Count	178 Count	65 Count
1790294816	81 Count	170 Count	63 Count
1790294215	76 Count	161 Count	59 Count
1790293615	71 Count	146 Count	55 Count
1790293014	67 Count	138 Count	52 Count
1790292413	63 Count	129 Count	49 Count
1790291812	56 Count	112 Count	43 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)