PenangAPRS Track

My position About ☰

reset

SV9KIR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV9KIR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764984154	297 Count	678 Count
1764982351	296 Count	677 Count
1764980548	295 Count	675 Count
1764978745	294 Count	672 Count
1764976942	293 Count	670 Count
1764975139	292 Count	668 Count
1764973336	291 Count	666 Count
1764971568	290 Count	664 Count
1764969765	289 Count	661 Count
1764967962	288 Count	656 Count
1764966159	287 Count	652 Count
1764964356	286 Count	650 Count
1764962553	285 Count	648 Count
1764960750	284 Count	645 Count
1764958947	283 Count	643 Count
1764957144	282 Count	641 Count
1764955341	281 Count	636 Count
1764953538	280 Count	634 Count
1764951735	279 Count	629 Count
1764949968	278 Count	623 Count
1764948165	277 Count	618 Count
1764946362	276 Count	615 Count
1764944559	275 Count	607 Count
1764942755	274 Count	603 Count
1764940952	273 Count	598 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)