PenangAPRS Track

My position About ☰

reset

SR2ST-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794344876	379 Count	741 Count	101 Count
1794343075	362 Count	714 Count	97 Count
1794341274	347 Count	680 Count	94 Count
1794339473	331 Count	656 Count	90 Count
1794337672	314 Count	625 Count	86 Count
1794335872	277 Count	594 Count	81 Count
1794334071	258 Count	551 Count	75 Count
1794332270	240 Count	521 Count	70 Count
1794330469	224 Count	482 Count	66 Count
1794328677	201 Count	449 Count	60 Count
1794326876	184 Count	417 Count	56 Count
1794325075	166 Count	384 Count	51 Count
1794323275	150 Count	355 Count	47 Count
1794321474	131 Count	326 Count	41 Count
1794319673	109 Count	275 Count	31 Count
1794317872	91 Count	247 Count	25 Count
1794316072	71 Count	206 Count	18 Count
1794314271	53 Count	168 Count	12 Count
1794312470	38 Count	117 Count	9 Count
1794310669	19 Count	73 Count	4 Count
1794308868	3 Count	2 Count	0 Count
1794307076	315 Count	956 Count	89 Count
1794305275	298 Count	910 Count	84 Count
1794303475	283 Count	863 Count	80 Count
1794301674	269 Count	819 Count	76 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)