PenangAPRS Track

My position About ☰

reset

IT9IRS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1786401031	73 Count	841 Count
1786400726	72 Count	825 Count
1786400422	71 Count	816 Count
1786400117	70 Count	807 Count
1786399507	68 Count	788 Count
1786399203	67 Count	776 Count
1786398898	66 Count	767 Count
1786398593	65 Count	756 Count
1786398289	64 Count	741 Count
1786397984	63 Count	725 Count
1786397679	62 Count	719 Count
1786397374	61 Count	707 Count
1786396765	59 Count	671 Count
1786396460	58 Count	648 Count
1786396156	57 Count	639 Count
1786395546	55 Count	624 Count
1786395241	54 Count	614 Count
1786394937	53 Count	607 Count
1786394632	52 Count	591 Count
1786394328	51 Count	583 Count
1786394023	50 Count	576 Count
1786393718	49 Count	567 Count
1786393413	48 Count	558 Count
1786393109	47 Count	550 Count
1786392804	46 Count	532 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)