PenangAPRS Track

My position About ☰

reset

OK1LOL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765660150	0 Count	4 Count
1765658346	40 Count	1004 Count
1765656544	39 Count	1000 Count
1765654740	38 Count	993 Count
1765652937	37 Count	985 Count
1765651134	36 Count	977 Count
1765649331	35 Count	969 Count
1765647528	34 Count	961 Count
1765645725	33 Count	953 Count
1765643922	32 Count	945 Count
1765643753	31 Count	945 Count
1765641950	30 Count	939 Count
1765640146	29 Count	933 Count
1765638343	28 Count	925 Count
1765636540	27 Count	917 Count
1765634737	26 Count	909 Count
1765632934	25 Count	900 Count
1765631131	24 Count	890 Count
1765618748	22 Count	812 Count
1765616945	21 Count	806 Count
1765615142	20 Count	800 Count
1765613339	19 Count	794 Count
1765611536	18 Count	788 Count
1765609733	17 Count	782 Count
1765607930	16 Count	776 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)