PenangAPRS Track

My position About ☰

reset

SP8KSR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8KSR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790314283	430 Count	615 Count	430 Count
1790312483	420 Count	600 Count	420 Count
1790310683	414 Count	588 Count	414 Count
1790308883	405 Count	573 Count	405 Count
1790307083	395 Count	558 Count	395 Count
1790305283	385 Count	543 Count	385 Count
1790303483	359 Count	510 Count	359 Count
1790301683	340 Count	486 Count	340 Count
1790299882	332 Count	473 Count	332 Count
1790298082	324 Count	459 Count	324 Count
1790296282	315 Count	445 Count	315 Count
1790294482	307 Count	432 Count	307 Count
1790292693	301 Count	420 Count	301 Count
1790290893	293 Count	407 Count	293 Count
1790289093	285 Count	394 Count	285 Count
1790287293	278 Count	382 Count	278 Count
1790285493	269 Count	368 Count	269 Count
1790283693	262 Count	355 Count	262 Count
1790281893	257 Count	344 Count	257 Count
1790280093	245 Count	327 Count	245 Count
1790278293	238 Count	316 Count	238 Count
1790276493	228 Count	301 Count	228 Count
1790274693	215 Count	282 Count	215 Count
1790272893	201 Count	262 Count	201 Count
1790249481	749 Count	982 Count	749 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)