PenangAPRS Track

My position About ☰

reset

SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794344352	67 Count	787 Count	58 Count
1794342551	60 Count	692 Count	52 Count
1794340751	50 Count	583 Count	43 Count
1794338950	39 Count	483 Count	34 Count
1794337149	29 Count	378 Count	25 Count
1794335348	21 Count	289 Count	18 Count
1794333548	13 Count	194 Count	12 Count
1794331747	6 Count	92 Count	6 Count
1794329946	119 Count	1036 Count	109 Count
1794328145	108 Count	946 Count	99 Count
1794326344	97 Count	846 Count	89 Count
1794324544	87 Count	753 Count	80 Count
1794322761	77 Count	662 Count	71 Count
1794320960	66 Count	562 Count	61 Count
1794319159	57 Count	473 Count	53 Count
1794317357	46 Count	363 Count	43 Count
1794315555	34 Count	261 Count	32 Count
1794313754	23 Count	182 Count	22 Count
1794311953	10 Count	92 Count	10 Count
1794310152	137 Count	1073 Count	124 Count
1794308351	123 Count	969 Count	111 Count
1794306548	113 Count	883 Count	102 Count
1794304747	99 Count	786 Count	89 Count
1794302944	86 Count	684 Count	77 Count
1794301154	74 Count	597 Count	67 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)