PenangAPRS Track

My position About ☰

reset

OK1CDJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1CDJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1764955696	93 Count	860 Count
1764952093	92 Count	860 Count
1764948490	91 Count	857 Count
1764944887	90 Count	857 Count
1764941302	89 Count	856 Count
1764937699	88 Count	856 Count
1764934096	87 Count	856 Count
1764930493	86 Count	856 Count
1764926890	85 Count	856 Count
1764923286	84 Count	853 Count
1764919700	83 Count	849 Count
1764916097	82 Count	843 Count
1764912494	81 Count	843 Count
1764908891	80 Count	843 Count
1764901688	78 Count	843 Count
1764898100	77 Count	843 Count
1764894497	76 Count	843 Count
1764890894	75 Count	843 Count
1764887291	74 Count	843 Count
1764883688	73 Count	843 Count
1764880085	72 Count	843 Count
1764876499	71 Count	843 Count
1764872896	70 Count	843 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)