PenangAPRS Track

My position About ☰

reset

SQ4VK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1764965528	879 Count	216 Count	123 Count
1764964646	872 Count	213 Count	122 Count
1764963745	865 Count	211 Count	121 Count
1764962844	857 Count	207 Count	120 Count
1764961943	850 Count	205 Count	119 Count
1764961043	844 Count	202 Count	119 Count
1764960141	837 Count	200 Count	118 Count
1764959240	828 Count	198 Count	117 Count
1764958339	823 Count	198 Count	117 Count
1764957439	816 Count	198 Count	117 Count
1764956538	809 Count	196 Count	116 Count
1764955637	803 Count	195 Count	116 Count
1764954736	796 Count	192 Count	116 Count
1764953835	788 Count	188 Count	115 Count
1764952934	781 Count	187 Count	114 Count
1764952034	775 Count	187 Count	114 Count
1764951133	766 Count	185 Count	112 Count
1764950232	759 Count	184 Count	111 Count
1764949331	751 Count	182 Count	110 Count
1764948431	744 Count	179 Count	109 Count
1764947530	736 Count	177 Count	107 Count
1764946629	728 Count	176 Count	106 Count
1764945729	719 Count	174 Count	104 Count
1764944828	714 Count	174 Count	104 Count
1764943927	706 Count	174 Count	104 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)