PenangAPRS Track

My position About ☰

reset

SP7TWA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TWA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1786421269	285 Count	925 Count
1786420369	284 Count	924 Count
1786419468	283 Count	923 Count
1786418567	282 Count	922 Count
1786417666	281 Count	921 Count
1786416765	280 Count	920 Count
1786415865	279 Count	919 Count
1786414063	277 Count	917 Count
1786413162	276 Count	916 Count
1786412279	275 Count	915 Count
1786411378	274 Count	914 Count
1786410477	273 Count	913 Count
1786409576	272 Count	912 Count
1786408676	271 Count	911 Count
1786407775	270 Count	910 Count
1786406874	269 Count	909 Count
1786405973	268 Count	908 Count
1786405072	267 Count	907 Count
1786404172	266 Count	906 Count
1786403271	265 Count	905 Count
1786402370	264 Count	903 Count
1786401469	263 Count	902 Count
1786400568	262 Count	900 Count
1786399668	261 Count	899 Count
1786398767	260 Count	898 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)