PenangAPRS Track

My position About ☰

reset

OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1764941619	463 Count	45 Count	19 Count
1764939692	461 Count	45 Count	19 Count
1764937765	459 Count	45 Count	19 Count
1764935838	457 Count	45 Count	19 Count
1764935432	456 Count	45 Count	19 Count
1764933505	454 Count	45 Count	19 Count
1764931578	449 Count	42 Count	16 Count
1764929652	447 Count	42 Count	16 Count
1764927725	445 Count	42 Count	16 Count
1764925798	443 Count	42 Count	16 Count
1764923871	441 Count	42 Count	16 Count
1764921945	439 Count	42 Count	16 Count
1764920018	437 Count	42 Count	16 Count
1764918091	435 Count	42 Count	16 Count
1764916165	433 Count	42 Count	16 Count
1764914238	431 Count	42 Count	16 Count
1764913832	430 Count	42 Count	16 Count
1764911905	428 Count	42 Count	16 Count
1764909978	426 Count	42 Count	16 Count
1764908052	424 Count	42 Count	16 Count
1764906125	422 Count	42 Count	16 Count
1764904198	420 Count	42 Count	16 Count
1764902271	418 Count	42 Count	16 Count
1764900345	416 Count	42 Count	16 Count
1764898418	414 Count	42 Count	16 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)