PenangAPRS Track

My position About ☰

reset

SP2GSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1792739000	67 Count	622 Count	55 Count
1792737199	58 Count	566 Count	47 Count
1792735399	50 Count	476 Count	40 Count
1792733598	42 Count	392 Count	33 Count
1792731798	35 Count	318 Count	27 Count
1792729997	27 Count	241 Count	20 Count
1792728197	19 Count	125 Count	13 Count
1792726396	11 Count	64 Count	6 Count
1792724595	4 Count	0 Count	0 Count
1792722801	151 Count	962 Count	130 Count
1792721000	143 Count	902 Count	123 Count
1792719199	136 Count	852 Count	117 Count
1792717399	127 Count	801 Count	109 Count
1792715598	118 Count	746 Count	101 Count
1792713798	111 Count	697 Count	95 Count
1792711997	103 Count	644 Count	88 Count
1792710197	95 Count	583 Count	81 Count
1792708396	86 Count	536 Count	73 Count
1792706596	78 Count	484 Count	66 Count
1792704795	69 Count	430 Count	58 Count
1792702994	62 Count	374 Count	52 Count
1792701200	50 Count	329 Count	45 Count
1792699399	41 Count	281 Count	37 Count
1792697598	33 Count	234 Count	30 Count
1792695798	24 Count	177 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)