PenangAPRS Track

My position About ☰

reset

PA1MT-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA1MT-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1780207150	317 Count	714 Count
1780205347	316 Count	711 Count
1780203581	311 Count	708 Count
1780201778	310 Count	705 Count
1780199974	309 Count	702 Count
1780198171	308 Count	699 Count
1780196368	307 Count	696 Count
1780194565	306 Count	693 Count
1780192761	305 Count	690 Count
1780190958	304 Count	687 Count
1780189154	303 Count	684 Count
1780187351	302 Count	681 Count
1780185548	301 Count	678 Count
1780183744	300 Count	675 Count
1780181979	295 Count	672 Count
1780180175	294 Count	669 Count
1780178372	293 Count	666 Count
1780176568	292 Count	663 Count
1780174765	291 Count	660 Count
1780172962	290 Count	657 Count
1780171158	289 Count	654 Count
1780169355	288 Count	651 Count
1780167552	287 Count	648 Count
1780165748	286 Count	645 Count
1780163945	285 Count	642 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)