PenangAPRS Track

My position About ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790310221	279 Count	685 Count	2 Count
1790309620	278 Count	684 Count	2 Count
1790309020	277 Count	684 Count	2 Count
1790308418	276 Count	683 Count	2 Count
1790307818	275 Count	682 Count	2 Count
1790307217	274 Count	681 Count	2 Count
1790306616	273 Count	680 Count	2 Count
1790306015	272 Count	679 Count	2 Count
1790305414	271 Count	678 Count	2 Count
1790304813	270 Count	677 Count	2 Count
1790304211	269 Count	677 Count	2 Count
1790303611	268 Count	676 Count	2 Count
1790303010	267 Count	675 Count	2 Count
1790302409	266 Count	674 Count	2 Count
1790301808	265 Count	673 Count	2 Count
1790301207	264 Count	672 Count	2 Count
1790300606	263 Count	666 Count	2 Count
1790300005	262 Count	665 Count	2 Count
1790299405	261 Count	664 Count	2 Count
1790298804	260 Count	663 Count	2 Count
1790298203	259 Count	662 Count	2 Count
1790297602	258 Count	661 Count	2 Count
1790297001	257 Count	660 Count	2 Count
1790296400	256 Count	659 Count	2 Count
1790295799	255 Count	658 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)