PenangAPRS Track

My position About ☰

reset

PE1PNX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PNX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773762909	540 Count	274 Count	209 Count
1773761105	539 Count	274 Count	209 Count
1773759302	538 Count	274 Count	209 Count
1773757498	537 Count	274 Count	209 Count
1773755735	532 Count	274 Count	209 Count
1773753932	531 Count	274 Count	209 Count
1773752128	519 Count	263 Count	198 Count
1773750325	514 Count	259 Count	194 Count
1773748521	512 Count	258 Count	193 Count
1773746717	510 Count	257 Count	192 Count
1773744913	509 Count	257 Count	192 Count
1773743110	508 Count	257 Count	192 Count
1773741306	507 Count	257 Count	192 Count
1773739502	506 Count	257 Count	192 Count
1773737699	504 Count	256 Count	191 Count
1773735895	501 Count	254 Count	189 Count
1773734140	494 Count	251 Count	187 Count
1773732336	476 Count	234 Count	170 Count
1773730532	474 Count	233 Count	169 Count
1773728726	445 Count	205 Count	141 Count
1773726923	444 Count	205 Count	141 Count
1773725114	442 Count	204 Count	140 Count
1773723311	441 Count	203 Count	140 Count
1773721507	440 Count	203 Count	140 Count
1773719703	439 Count	202 Count	140 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)