PenangAPRS Track

My position About ☰

reset

PA3GPU-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3GPU-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1773750224	62 Count	391 Count
1773746621	61 Count	387 Count
1773743018	60 Count	385 Count
1773739415	59 Count	383 Count
1773735812	58 Count	372 Count
1773732209	57 Count	330 Count
1773728627	56 Count	264 Count
1773725024	55 Count	261 Count
1773721421	54 Count	259 Count
1773717818	53 Count	257 Count
1773714216	52 Count	250 Count
1773710613	51 Count	248 Count
1773707022	50 Count	246 Count
1773703419	49 Count	244 Count
1773699816	48 Count	242 Count
1773696213	47 Count	240 Count
1773692610	46 Count	233 Count
1773689007	45 Count	231 Count
1773685420	44 Count	229 Count
1773681817	43 Count	227 Count
1773678214	42 Count	225 Count
1773674611	41 Count	223 Count
1773671009	40 Count	216 Count
1773667406	39 Count	214 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)