PenangAPRS Track

My position About ☰

reset

SQ9PQL-00 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PQL-00. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773726455	152 Count	156 Count	103 Count
1773725551	146 Count	148 Count	98 Count
1773724647	143 Count	145 Count	96 Count
1773723743	140 Count	142 Count	94 Count
1773722840	137 Count	139 Count	92 Count
1773721936	134 Count	136 Count	90 Count
1773721032	131 Count	132 Count	88 Count
1773720128	128 Count	129 Count	86 Count
1773719225	125 Count	126 Count	84 Count
1773718321	122 Count	122 Count	82 Count
1773717417	119 Count	120 Count	80 Count
1773716604	116 Count	117 Count	78 Count
1773715701	113 Count	114 Count	76 Count
1773714797	110 Count	111 Count	74 Count
1773713893	107 Count	108 Count	72 Count
1773712989	104 Count	106 Count	70 Count
1773712085	101 Count	103 Count	68 Count
1773711181	98 Count	101 Count	66 Count
1773710278	95 Count	98 Count	64 Count
1773709374	92 Count	95 Count	62 Count
1773708470	89 Count	92 Count	60 Count
1773707568	86 Count	89 Count	58 Count
1773706663	83 Count	86 Count	56 Count
1773705759	80 Count	82 Count	54 Count
1773704855	77 Count	78 Count	52 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)