PenangAPRS Track

My position About ☰

reset

SP8C-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8C-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790303654	71 Count	188 Count	71 Count
1790301854	71 Count	188 Count	71 Count
1790300054	71 Count	188 Count	71 Count
1790298254	71 Count	188 Count	71 Count
1790296454	71 Count	188 Count	71 Count
1790294653	71 Count	188 Count	71 Count
1790292853	71 Count	188 Count	71 Count
1790291053	71 Count	188 Count	71 Count
1790289253	71 Count	188 Count	71 Count
1790287453	71 Count	188 Count	71 Count
1790285652	71 Count	188 Count	71 Count
1790283852	71 Count	188 Count	71 Count
1790282052	71 Count	188 Count	71 Count
1790280252	71 Count	188 Count	71 Count
1790278451	71 Count	188 Count	71 Count
1790276651	71 Count	188 Count	71 Count
1790274851	71 Count	188 Count	71 Count
1790273051	71 Count	188 Count	71 Count
1790271258	71 Count	188 Count	71 Count
1790269457	71 Count	188 Count	71 Count
1790267657	71 Count	188 Count	71 Count
1790265857	71 Count	188 Count	71 Count
1790264057	71 Count	188 Count	71 Count
1790262257	71 Count	188 Count	71 Count
1790260457	47 Count	164 Count	47 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)