PenangAPRS Track

My position About ☰

reset

SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790307636	23 Count	20 Count	0 Count
1790307035	22 Count	19 Count	0 Count
1790306434	21 Count	18 Count	0 Count
1790305833	20 Count	17 Count	0 Count
1790305232	19 Count	16 Count	0 Count
1790304031	17 Count	14 Count	0 Count
1790303430	16 Count	13 Count	0 Count
1790302829	15 Count	12 Count	0 Count
1790302229	14 Count	11 Count	0 Count
1790301628	13 Count	10 Count	0 Count
1790301026	12 Count	9 Count	0 Count
1790300455	7 Count	8 Count	0 Count
1790299854	6 Count	7 Count	0 Count
1790299253	5 Count	6 Count	0 Count
1790298653	4 Count	5 Count	0 Count
1790298052	3 Count	4 Count	0 Count
1790297452	2 Count	3 Count	0 Count
1790296850	1 Count	2 Count	0 Count
1790296249	0 Count	1 Count	0 Count
1790295648	422 Count	1005 Count	41 Count
1790295048	421 Count	999 Count	41 Count
1790294447	420 Count	998 Count	41 Count
1790293846	419 Count	997 Count	41 Count
1790293245	418 Count	996 Count	41 Count
1790292644	417 Count	995 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)