PenangAPRS Track

My position About ☰

reset

SP8NCG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8NCG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790295624	422 Count	529 Count
1790293824	417 Count	526 Count
1790292032	412 Count	523 Count
1790290231	405 Count	520 Count
1790288431	400 Count	517 Count
1790286630	394 Count	514 Count
1790284829	388 Count	511 Count
1790283028	382 Count	508 Count
1790281228	376 Count	505 Count
1790279427	370 Count	502 Count
1790277626	364 Count	499 Count
1790275825	358 Count	496 Count
1790274024	353 Count	494 Count
1790272224	349 Count	491 Count
1790270433	343 Count	488 Count
1790268632	337 Count	485 Count
1790266831	331 Count	482 Count
1790265031	325 Count	477 Count
1790263230	319 Count	470 Count
1790261429	313 Count	467 Count
1790259629	307 Count	464 Count
1790257828	301 Count	461 Count
1790256027	295 Count	458 Count
1790254226	289 Count	455 Count
1790252425	283 Count	452 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)