PenangAPRS Track

My position About ☰

reset

SP3DVO-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3DVO-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1786407201	68 Count	787 Count
1786406300	67 Count	778 Count
1786405399	66 Count	767 Count
1786404499	65 Count	760 Count
1786403598	64 Count	751 Count
1786402697	63 Count	742 Count
1786401797	62 Count	732 Count
1786400896	61 Count	722 Count
1786399995	60 Count	712 Count
1786399094	59 Count	702 Count
1786398194	58 Count	692 Count
1786397293	57 Count	682 Count
1786396393	56 Count	672 Count
1786395494	55 Count	662 Count
1786394593	54 Count	652 Count
1786393690	53 Count	643 Count
1786392789	52 Count	633 Count
1786391884	51 Count	622 Count
1786390984	50 Count	611 Count
1786390101	49 Count	597 Count
1786389200	46 Count	582 Count
1786388299	45 Count	565 Count
1786387398	44 Count	548 Count
1786386498	43 Count	530 Count
1786385597	42 Count	518 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)