PenangAPRS Track

My position About ☰

reset

SP6ICO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6ICO-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790306802	612 Count	500 Count	380 Count
1790305001	609 Count	498 Count	378 Count
1790303201	606 Count	496 Count	376 Count
1790301400	603 Count	494 Count	374 Count
1790299599	600 Count	492 Count	372 Count
1790276206	561 Count	466 Count	346 Count
1790274405	558 Count	464 Count	344 Count
1790272604	555 Count	462 Count	342 Count
1790270804	552 Count	460 Count	340 Count
1790269003	549 Count	458 Count	338 Count
1790267202	546 Count	456 Count	336 Count
1790265402	543 Count	454 Count	334 Count
1790263601	540 Count	452 Count	332 Count
1790261800	537 Count	450 Count	330 Count
1790260000	534 Count	448 Count	328 Count
1790258199	531 Count	446 Count	326 Count
1790256398	528 Count	444 Count	324 Count
1790254605	525 Count	442 Count	322 Count
1790252804	522 Count	440 Count	320 Count
1790251004	519 Count	438 Count	318 Count
1790249203	516 Count	436 Count	316 Count
1790247402	513 Count	434 Count	314 Count
1790245602	510 Count	432 Count	312 Count
1790243801	507 Count	430 Count	310 Count
1790242000	504 Count	428 Count	308 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)